WDW-1kN/2kN/5kN/10kN/20kN/50kN/100kN Electronic Universal Testing Machine (Standard type)(CE)

1 Introduction:

1) tensile, compression, bending, torsion, shearing testing and researching with variety of metal, nonmetal material and composite material under room temperature.

2) sample of thin plate, panel, belt, foil, flat bar, wire, bar, proximate matter, pipe, sheet, square, round, rectangle, and annular shaped, cast iron, nonmetal alloy of cast iron, pipe section, proportional and non-proportional(index: k= 11.3 or 5.65), fully wall thickness of longitudinal and horizontal peeling strip, rectangle and round section.

3) test with variety of metal, thin metal, wire, fine wire, fiber, elastomer, foam.

4) test with textile, food, medicine, cosmetic, biological material.

5) tensile, peeling and welding strength test with electronic component.

6) Peeling, bending and fastening property for PCB circuit board

7) test with wooden, paper, film production and other nonmetal material.

8) strain relaxation and adhesive strength test.

2  Key Words

Gauge length, original gauge length, final gauge length, extensometer gauge length, parallel length, extension, elongation, percentage elongation, percentage permanent extension, percentage elongation after fracture, percentage total elongation at fracture, percentage reduction of area, stress.

Max. Force, tensile strength, yield strength, upper yield strength, lower yield strength, proof strength non-proportional extension.

3 Standards

1) ASTM E8 / E8M - 16a Standard Test Methods for Tension Testing of Metallic Materials

2) BS EN ISO 6892-1:2016 Metallic materials. Tensile testing. Method of test at room temperature

3) ASTM E9 - 09 Standard Test Methods of Compression Testing of Metallic Materials at Room Temperature

4) ASTM D695 - 15 Standard Test Method for Compressive Properties of Rigid Plastics

5) ASTM D4018 - 17 Standard Test Methods for Properties of Continuous Filament Carbon and Graphite Fiber Tows

4 Specifications