试验机_济南恒瑞金试验机有限公司

300kN排氣道垂直承載力試驗：壓力試驗機上下壓板間有效間距1m以上，以3根長度爲標准住宅層高的排氣道，分別截取1m管長爲測試試件，試件兩端平整且互相平行。hrjtest；（a）將試件直立于壓力機上，試件兩端應墊厚度3mm～5mm面積大于試件口徑的木質墊板，垂直度不應大于2mm/m，否則用木片或硬質薄片墊平；（b）以恒定4kN/s加荷速度加載，使試件破壞。記錄試件破壞時的荷載值即爲該試件的垂直承載值，精確至1kN；（c）取3個試件試驗結果的算術平均值爲排氣道承載力檢測結果，精確至1kN。

住宅排氣道制品垂直承載力測試；廚房排油煙氣管道試驗機；排煙道制品垂直承載力試驗機；玻璃纖維排氣管道垂直承載力試驗機；水泥排氣管道承載力試驗機；立管管道制品垂直承載力試驗機；通風換氣集中式排氣管道試驗機；鋼絲網水泥排煙道承載力試驗機；高強玻鎂防火板管道試驗機；300kN排氣煙道承載力試驗機；300kN等截面排氣管道試驗機；300kN變截面排氣管道壓力試驗機；600x500mm排氣道承載力試驗機；500x300mm排氣道承載力試驗機；800x500mm排煙道承載力試驗機；纖維增強水泥排氣道抗彎強度試驗機；500x400mm衛生間排氣道承載力試驗機；110kN排氣管道垂直承載力試驗；hrjtest；90kN排氣道垂直承載力試驗；CA/CB/CD/CG/CH/CK廚房排氣道試驗機；WA/WB/WG/WK衛生間排氣道試驗機；hrjtest；WWB/WWG/WWK毗連雙衛生間排濁氣管道試驗機；1000kN排水管外壓荷載伺服試驗機；1000kN預制混凝土管片抗彎曲試驗機；200kN腳手架鋼管支架構件試驗機； JG/T194-2018住宅廚房和衛生間排煙（氣）道制品；JGJ/T455-2018住宅排氣管道系統工程技術標准；CECS 390-2014住宅排氣道系統應用技術規程；JC/T 854玻璃纖維增強水泥排氣管道；GB/T 15231玻璃纖維增強水泥性能試驗方法；纖維增強水泥制品力學性能試驗機；GB 50096-2011住宅設計規範；GB 50368住宅建築規範；

Ventilating duct Vertical Load Tester；Ventilating Duct Vertical Compression Tester；Residential Exhaust Pipe Vertical Load Tester；hrjtest；Residential Exhaust Pipe Compress Load Tester；Ventilating Duct Load Compress Tester；HRJ Tester；Servo Ventilating Duct Load Tester；Kitchen Exhaust Tract Load Tester；Toilet Exhaust Tract Compression Tester；Kitchen Toilet Smoke Tract Vertical Load Tester；Technical standard for residential exhaust pipe system engineering；Ventilating duct for residential kitchen and bathroom；HRJ Tester；Technical specification for application of exhaust duct system in residential buildings；Glass fiber reinforced cement duct for ventilation；jnshiyanji；Test methods for the properties of glass fibre reinforced cement；Design code for residential buildings；Residential building code；Kitchen toilet exhaust smoke tract Products；Centralized exhaust system for residential kitchen or bathroom：Centralized exhaust system for residential building with coal range；Discharging oil fume Fire prevention Check valve；hrjtest；Kitchen toilet exhaust (smoke) tract Products；Drainage Pipes Compressive Load Servo Tester；Reinforced Concrete Segment Bending Tester；Disk Lock Steel Tubular Scaffold Components Tester；